Note: Target capture only works only when Wide Target Assist is on.
To customize Controls:
- Tap your profile picture
- Choose Controls > Customize
Here you can adjust the position, size, and opacity of the buttons.
Remember to run a test Battle to check whether the modified Controls are the perfect fit for you.
In this tab, you can also choose:
- Targeting Assist System
- Crosshair type
- Weapon Reload System
- Damage Display > Tap the "i" button to find out the visual display of different damage types:
To start fighting, tap "Battle" and choose the game mode.
To access the Battle Settings, tap the Settings button in the upper-left corner of the screen.
You can also change Mech or leave the battle. After you tap "Change Mech", your current one will be destroyed.
If you leave the Battle, you'll get the summary when it's over. Your Rewards will depend on the time you spent fighting and your contribution to the Battle Results. Note that you may lose progress for your Event Objectives.
During the Battle, move the joystick to navigate. Pull it up to Sprint, briefly boosting your Mech's speed. Sprint's cooldown is 10 seconds.
When your Mech is being attacked, a red signal helps you to locate your enemy.
When an enemy fires a Javelin Rack or a Rocket Mortar at your position, you'll see a warning a second before the projectiles hit.
The notification will be shown as long as you're in the damage radius. Keep this in mind while in the heat of the battle. It could make the difference between victory and defeat.